WIRE HARNESS, AOG 24"

Restore reliable ignition and control module communication on your outdoor cooking equipment with this exact-match Wiring Harness, specifically engineered for 24″ American Outdoor Grill models. This replacement component resolves common electrical failures—including intermittent sparking, unresponsive burners, and corroded terminal connections—without requiring an appliance overhaul.

Factory-Spec Electrical Routing

Registered as part number 193-24-B-48A, this assembly mirrors the original equipment manufacturer layout found throughout our catalog of Grills, Grill Islands and Outdoor Kitchen Appliances. The harness preserves proprietary connector geometries and insulated wire gauges necessary to safely route power between the primary controller, valve actuators, and ground points inside a sealed cooking environment.

Compatibility Verification

Install only after confirming your grill matches this specification. Locate the manufacturer identification plate and verify the serial prefix aligns with the listed item code. Physically compare the new loom against the factory wiring bundle to match terminal block configurations, splice junctions, and heat-shrink tubing placements. Reviewing your official documentation confirms whether your specific 24″ configuration requires these exact termination points.

• Precise wire length calibration prevents binding near sharp hood hinges or pivot arms
• Thermoset insulation shields low-voltage spark generation components from extreme thermal cycles
• Drop-in swap eliminates diagnostic guesswork during routine maintenance cycles

This unit weighs exactly 1.50 lbs per EA and slots directly into established AOG Replacement Parts inventories. Secure the correct electrical pathway for your outdoor setup today to guarantee consistent burner firing and extended component lifespan.