3/4" MANIFOLDS LP

Engineered for 3/4-inch liquid propane manifolds, the Platinum Ignition System pairs a hot surface igniter with a 24-volt transformer to deliver up to 680,000 BTU/hr of consistent gas output for outdoor fire pits, tables, and heaters. Designed to replace unreliable piezo units, this ignition module eliminates common failure points found in standard outdoor fire feature controls while maintaining direct mechanical and gas-line compatibility with existing 3/4" manifold configurations.

A purpose-built wind cage shields internal pilot components against driving rain and crosswinds, ensuring stable spark delivery in exposed patio environments. Programmable ignition parameters let technicians dial in precise firing intervals, which significantly reduces rapid cycling faults and heat stress on the electrode. When routine inspection or part replacement is required, the accessible housing supports full field serviceability without disassembling the entire fire feature. Built-in LED indicators display real-time status codes, allowing installers to identify voltage drops or grounding issues in seconds. For total environmental isolation at the gas line, the system seals cleanly when mounted alongside the Warming Trends WATER STOP® fitting, preventing debris and moisture intrusion at the valve interface.

• Specifically rated for 3/4-inch manifold piping with liquid propane fuel
• Consolidates power regulation and flame initiation through an integrated 24V transformer and hot surface igniter
• Handles maximum continuous loads of 680,000 BTU/hr without capacity throttling
• Factory-adjusted switching logic prevents short-cycle burnout and stabilizes flame propagation
• Field-repairable architecture paired with LED diagnostic readouts for instant fault mapping

This all-in-one ignition package removes guesswork from fire feature electrical integration by providing pre-matched transformers and ignitors calibrated for heavy-duty propane applications. Installers get a rugged, weather-shielded control solution that aligns with existing plumbing dimensions while cutting down on warranty callbacks caused by faulty sparking or moisture damage.