1/2" FLARE X 1/2" F.I.P.
$7.99
Bridge pressure-rated systems using this 1/2-inch Steel Flare to FIP connector, which couples a 1/2-inch flared tube to a 1/2-inch Female Iron Pipe (FIP) thread. Built from steel, this fitting provides the structural strength required for demanding fluid and gas transfer applications.
The connector serves as a direct interface between differing connection standards. One end accommodates a 1/2-inch flare, accepting a matching flared tube for secure retention. The opposing end is threaded 1/2 inches FIP, allowing you to screw the assembly onto any compatible male pipe thread. This dual-profile design eliminates the need for multiple transition couplings by integrating the flare grip and female thread into a single steel unit.
This configuration supports installations where tubing must transition into a piped network. Common applications include:
- Connecting flared lines to threaded valves, regulators, or compressors.
- Adapting refrigeration and air conditioning circuits where flared tubing meets threaded ports.
- Converting flared outputs to standardized pipe threads in mechanical or heating systems.
- Fuel transmission setups involving steel lines and threaded reservoirs.
Ensure your system utilizes 1/2-inch sizing standards before installation. Verify that the mating flared tube matches the flare specification and that the receiving component possesses the corresponding 1/2-inch male thread to complete the connection securely.